Preslav 83, BG-9700 Shoumen
0888 626 935; 
stdimpex@stdimpex.com» Sanitary equipment» Flushing cisterns» Pre-wall installation elements with flushing cistern» Jog side supporting
Jog side supporting
Dry mounting toilet cistern for suspended toilet bowl, with frontal activation.
ident 00121
art. 5-384-450
Dry mounting build-in element with transversal console, build-in height 1180mm and build-in width of 800 - 1300 mm. It is intended for installation in partition walls for iskoristek space in the case of building with sanitary shaft wide between 800 and 1300 mm and as a free-standing element for pre-wall installation in dry mounting. It is used for the installation of wall WC ceramics
- prefabricated supporting frame coated with blue lacquer
- transversal consoles, coated with blue lacquer with two adjustable legs (2 x 250mm) and adequate fixing elements
- flushing cisterns DUO with dual flushing. If the START – STOP button is installed works with single flush START – STOP technique.
- *High capacity: 6 or 9 l, factory default settings 9 l
- *Low quantity: 3 or 4.5 l
- moisture insulation with styrofoam pads installed in toilet cistern
- two console supporting legs for installation on existing floor adjustable by height (0 – 240 mm)
- two threaded rods with nuts M12 for fixing suspended toilet with axial distance of 180 or 230mm
- pre-installed angle valve 1/2'' on the right side of the lid
- build-in protection for box culvert
- pre-installed PE wall discharge ø 90/ ø 110 with gaskets
- Ø 90 mm collar sets
- fixing material
- without flushing plates
- factory default of toilet cistern is 9 litres and can only be changed by regulating discharge valve for the quantity of 9 or 6 litres. The lower quantity is NOT changed.
- fill valve must remain at factory default setting!
